Hi Patrick & Alex,
Nems Provided floor plan with (25) add-on stations.
I run with the measurements I gathered Wednesday to recreated the area marked on the yellow box above.
However I think is best if I go there again and bring my laptop and make a more accurate lay out.
The support columns are driving me insane.
I need to add them on site and make sure what we can do about it.
so far it seems feasible.
We are swamped with work the rest of this week
I can be there Tuesday morning and spend at least 3 hours there.
basically measuring a wall and adding it to the drawing one by one on the spot to minimize errors.
All the stations are based on 6' on the spine and 6' on the return (Low panels on the window side)
the electrical running on the spine and the first 24" return panel.
(1) 6' x20" credenza top on the spine
(1) 50"L x 28"W sit stand table on the return side
(1) Lateral drawer. (1) 36"x24' white board.
However I think is best if I go there again and bring my laptop and make a more accurate lay out.
The support columns are driving me insane.
I need to add them on site and make sure what we can do about it.
so far it seems feasible.
We are swamped with work the rest of this week
I can be there Tuesday morning and spend at least 3 hours there.
basically measuring a wall and adding it to the drawing one by one on the spot to minimize errors.
All the stations are based on 6' on the spine and 6' on the return (Low panels on the window side)
the electrical running on the spine and the first 24" return panel.
(1) 6' x20" credenza top on the spine
(1) 50"L x 28"W sit stand table on the return side
(1) Lateral drawer. (1) 36"x24' white board.
